Skip to content

How to fix a TVIP remote control problem

Check the remote batteries, then reset the IR remote code page when a TVIP remote control stops working.

Updated November 14, 2026 1 min read


TVIP boxes are used to watch IPTV content. They are almost the same as MAG boxes but use different software. For an introduction and setup steps, read what TVIP is and how to set it up.

A common TVIP problem is a remote control that does not work. This guide shows how to fix it.

Check the batteries first

Before you start, test whether the problem is the battery. Press a few buttons on the remote and check whether the red light blinks.

  • If the red light does not blink, the battery is the problem. Change the batteries.
  • If the red light still does not blink after you change the batteries, the remote control is broken and you need a new one.
  • If the red light blinks but the remote does not work, the problem is the remote control IR (infrared) signal. Follow the steps below.

Fix the TVIP IR remote

  1. Press Setting (left of S.INFO) and Recall (left of 0) at the same time.
  2. Point the remote at the box and press and hold S.INFO for 10 seconds.

This process changes the IR remote code page. After 10 seconds, the box shows the message IR remote code page was changes. The TVIP remote control should work again.

More in Troubleshooting

Still stuck?

Our support team can help you set up your device or fix a problem.

Contact support